MV Drilling Jig or Device Holder - 10320

Drilling Jig for Handlebars, also possible to be used as Device Holder

Drilling a borewhole in the center of a round rod is even difficult for a skilled person.

With this drilling jig a running off of the drill impossible. As worldwide almost all handlebars have an outside Ø of 22 mm, this device with a width of 10 mm is interesting for everybody.

The drilling jig consists of a hole at the top and the side, in which a Ø 25 mm ball (article-no. 10205) can be fixed. Thus the gauge even can be used as device holder.

The ball can be ordered optionally.

All balls are provided with a rubber ring and therefore are non-slip and vibration-damped.

All MV accessories were assembled and tested at original motorcycles - without foreign modifications.

• Print this page
• Compare this item

Drilling Jig for Handlebars, also possible to be used as Device Holder

Drilling a borewhole in the center of a round rod is even difficult for a skilled person.

With this drilling jig a running off of the drill impossible. As worldwide almost all handlebars have an outside Ø of 22 mm, this device with a width of 10 mm is interesting for everybody.

The drilling jig consists of a hole at the top and the side, in which a Ø 25 mm ball (article-no. 10205) can be fixed. Thus the gauge even can be used as device holder.

The ball can be ordered optionally.

All balls are provided with a rubber ring and therefore are non-slip and vibration-damped.

All MV accessories were assembled and tested at original motorcycles - without foreign modifications.

• Print this page
• Compare this item