Cookie-Einstellungen
Diese Website benutzt Cookies, die für den technischen Betrieb der Website erforderlich sind und stets gesetzt werden. Andere Cookies, die den Komfort bei Benutzung dieser Website erhöhen, der Direktwerbung dienen oder die Interaktion mit anderen Websites und sozialen Netzwerken vereinfachen sollen, werden nur mit Ihrer Zustimmung gesetzt.
Konfiguration
Technisch erforderlich
Diese Cookies sind für die Grundfunktionen des Shops notwendig.
"Alle Cookies ablehnen" Cookie
"Alle Cookies annehmen" Cookie
Ausgewählter Shop
CSRF-Token
Cookie-Einstellungen
Individuelle Preise
Kunden-Wiedererkennung
Kundenspezifisches Caching
PayPal-Zahlungen
Session
Währungswechsel
Komfortfunktionen
Diese Cookies werden genutzt um das Einkaufserlebnis noch ansprechender zu gestalten, beispielsweise für die Wiedererkennung des Besuchers.
Merkzettel
Statistik & Tracking
Endgeräteerkennung
Partnerprogramm
LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch
- Réf. d'article : 1185
Avantages
- Le processus de paiement par carte de crédit s'effectue via PayPal. Vous n'avez pas besoin d'un compte Paypal pour cela. C'est pourquoi nous vous demandons de choisir PayPal, vous serez alors redirigé vers le paiement par carte de crédit.
- Propre fabrication et développement
- Par les motards - pour les motards
LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch For mounting two VA holders, black...plus
LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch
For mounting two VA holders, black plastic coated, are used, which are simply attached to existing screws on the fairing. Longer new screws are provided, a rubber strip beats the panel against scratching.
The lamp cables can be obtained by either central mini-adhesive pads or cable grommet and hole (see photo).
The 3 Power LEDs provide a very good light output just with a current consumption of just 0.6 amps (7.5 watts) with 12.5 volts. The lamps are E-approved and do not need to be registered or demonstrated by TÜV (German Association for Technical Inspection).
The supplied wiring harness is pre-assembled to simplify installation.
The two LED fog lamps have about 120 degrees of illumination.
Switching is done with special electronics by double-clicking with the headlight flasher switch. Thus, the lamps can be switched at any time without having to take your hands off the handlebar.
A MotoBozzo switch control cable is connected to the on-board socket ignition plus, another to the high-beam plus cable. Thus, the system works completely independently, without affecting the CanBus system!
Function MotoBozzo switch:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off by 2 x short trigger light flashing/pass switch (click-click) or also switched on again.
After switching off the ignition, the lamps light up for about 60 seconds - Coming Home function.
If this is annoying, simply switch off by double-clicking.
The operating status is indicated by an LED.
If it is desired that the lamps are switched off after starting, simply pull off the purple wire and instead clamp the green wire.
These lights, switched on during the day, increase your safety, because as motorcyclist you are much better seen!
Scope of supply.
2 pcs. VA holders, plastic coated, incl. 2 LED-fog lights (each with 75 Watt)
1 pc. harness with relay, MotoBozzo switch and separate fuse (all pre-wired)
1 pc illustrated instructions
For mounting two VA holders, black plastic coated, are used, which are simply attached to existing screws on the fairing. Longer new screws are provided, a rubber strip beats the panel against scratching.
The lamp cables can be obtained by either central mini-adhesive pads or cable grommet and hole (see photo).
The 3 Power LEDs provide a very good light output just with a current consumption of just 0.6 amps (7.5 watts) with 12.5 volts. The lamps are E-approved and do not need to be registered or demonstrated by TÜV (German Association for Technical Inspection).
The supplied wiring harness is pre-assembled to simplify installation.
The two LED fog lamps have about 120 degrees of illumination.
Switching is done with special electronics by double-clicking with the headlight flasher switch. Thus, the lamps can be switched at any time without having to take your hands off the handlebar.
A MotoBozzo switch control cable is connected to the on-board socket ignition plus, another to the high-beam plus cable. Thus, the system works completely independently, without affecting the CanBus system!
Function MotoBozzo switch:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off by 2 x short trigger light flashing/pass switch (click-click) or also switched on again.
After switching off the ignition, the lamps light up for about 60 seconds - Coming Home function.
If this is annoying, simply switch off by double-clicking.
The operating status is indicated by an LED.
If it is desired that the lamps are switched off after starting, simply pull off the purple wire and instead clamp the green wire.
These lights, switched on during the day, increase your safety, because as motorcyclist you are much better seen!
Scope of supply.
2 pcs. VA holders, plastic coated, incl. 2 LED-fog lights (each with 75 Watt)
1 pc. harness with relay, MotoBozzo switch and separate fuse (all pre-wired)
1 pc illustrated instructions
Marque de moto: | BMW |
Modèle de moto: | BMW S1000XR bis 2019 |
Type de produit: | Zusatzleuchten |
Lire, écr. et débatt. des analyses…plus
Évaluations de clients pour "LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch"
Écrire une évaluation
Les évaluations sont publiées après vérification.
Ilmberger
BMW S1000R and S1000RR Street 2015+ Carbon Rear...
419,90 €
*
Réf. d'article : rha214s100nk
MV Motorrad Technik GmbH
MV repose-pied passager pour le BMW S1000XR...
157,38 €
*
Réf. d'article : 908654
MV Motorrad Technik GmbH
MV Vario adjustable Flexible Rider's Footrest...
547,40 €
*
Réf. d'article : 908649S1000R2021
Ilmberger
BMW S1000R up to 2016 Carbon Belly Pan
À partir de 720,80 €
*
Réf. d'article : veu215s100nk
AC Schnitzer
Support de plaque AC Schnitzer sur le côté pour...
289,00 €
*
Réf. d'article : s700-68814-15
MV Motorrad Technik GmbH
adaptateur de guidon rond - modèles avec 22mm Ø...
À partir de 128,00 €
*
Réf. d'article : 90002
MV Motorrad Technik GmbH
Poids du guidon MV avec horloge pour la BMW R18
116,09 €
*
Réf. d'article : 10388
Ilmberger
BMW RnineT and Scrambler 2016 Carbon Tank Cover...
199,90 €
*
Réf. d'article : tal004ninetk
MV Motorrad Technik GmbH
MV adaptateur de guidon rond BMW S1000XR
148,00 €
*
177,50 €
*
Réf. d'article : 901446
MV Motorrad Technik GmbH
MV set de goupilles antidérapantes pour...
11,73 €
*
Réf. d'article : 10391
MV Motorrad Technik GmbH
MV repose-pied pilote – ajustable hydraulique...
1 895,20 €
*
Réf. d'article : 907800
Ilmberger
BMW S1000R 2017+ Carbon Mounting Kit for Carbon...
34,90 €
*
Réf. d'article : veh208S117nk
MV Motorrad Technik GmbH
MV - DUCATI - Le premier adaptateur de guidon...
128,00 €
*
168,25 €
*
Réf. d'article : SW10037
MV Motorrad Technik GmbH
MV Repose-pieds souples conducteur
515,20 €
*
Réf. d'article : 908649-deauville
MV Motorrad Technik GmbH
MV abaissement des repose-pieds pour le...
157,38 €
*
Réf. d'article : 907953
Ilmberger
Carbon Haltekit für Lenkerverkleidung für BMW R...
129,90 €
*
Réf. d'article : vhk014ninetk
Ilmberger
Carbon Seitendeckel links am Tank für BMW S1000...
299,90 €
*
Réf. d'article : sdl021s119sk
Ilmberger
Carbon Schwingenabdeckung rechts für BMW S1000...
229,90 €
*
Réf. d'article : scr024s119sk