Honda CRF 1000L Africa Twin Adventure LED Fog Light Set

• Honda CRF 1000L Africa Twin Adventure Sports LED - Fog lamps with MotoBozzo-Switch-2
• Lamps swivel with it, since they are mounted on the fork bridge.
• Electronic control Relay-free, switchable by mini push-button.
• Honda indicator lamp in the valve housing is controlled.

Our new LED fog light set on the Honda CRF 1000L ADV, pre-wired ready to plug in. The holder is a 4-part VA holder, which is simply screwed to existing fork bridge screw connections.
For the Adventure, a retaining arm extension is also supplied to stay under the crash bar when the handlebars are turned in.
The cable harness supplied is a perfect fit and completely pre-assembled to simplify installation - see photo. The special accessory connector prepared by Honda can be found at the top behind the speedo unit. Our matching Honda cable connector is plugged into it, including a coupling for existing navigation system etc. Thus no further cables are connected to the Africa Twin!
No more soldering or bumbling current thieves/cable taps, no more connection to the battery/flying fuse necessary!
Switching is done by MotoBozzo-Switch-2 electronics - this is controlled by a mini push button, which can be glued on with a 3M adhesive pad. So you can change gears at any time without taking your hands off the handlebars, if the button is mounted like in the example photo.

Fully electronically controlled without relay!

Ready to plug in assembly can be seen here:

Data LED projector lamp:
Power/Power 12V: 6W
Power consumption/consumption 12V: 0,5A
LEDs and type 1 piece Osram OBF LED
Fastening Points 2 M6
Approval ECE, SAE, EMC
Ventilation / Ventilation Membrane
Material housing/material Housing Aluminium / Alloy
Lens material / Front lens material PC hardened / hard coated
Temperature range/operation range -40 - +80°c
Protection class / IP Classification IP6K9K / IP68
- Aluminium housing, black powder-coated and structured
- Corrosion protection for 480h salt spray
- extremely compact design
- ECE , SAE, EMC approved

New generation 70mm LED fog light with integrated control unit. With only 6 Watt power consumption super bright, additional wiring harnesses for an external control unit are not necessary. The headlight is thousandfold in serial use by motorcycle manufacturers. Nitto Denko Air Cap ventilation. Clear light/dark boundary and concentrated illumination without light diffusion.
Very low installation depth (55mm).

Function MotoBozzo-Switch-2 electronics:

After switching on the ignition the lamps turn on automatically.
Now the lamps can be switched off - or also on again by 1 x short keystroke.
If it is desired that the lamps are switched off after starting, just disconnect the purple wire at the connector and connect the prepared green wire instead.
No matter which switching state was last selected, the lamps always switch on when the ignition is switched on (delivery state purple wire plugged in), so it is impossible to forget to switch on. This can be changed by replugging, then the lamps are always switched on when the ignition is switched on.
first switched off (optionally repositionable, green wire).

These lights, switched on during the day, increase your safety, because you are much better seen as a motorcyclist!

No TÜV demonstration/registration necessary, because LED lights have an E-mark!

Scope of delivery:

2 VA-brackets with 2 LED fog lamps pre-mounted, MotoBozzo-Switch-2, Minitaster and Honda special accessory plug with coupling
1 illustrated assembly instruction