MV - BMW Models - Closer - higher - further The adjustable tube handlebar adapter for BMW K1

MV - BMW Models - Higher - Closer – Further
The first adjustable tube handlebar adapter for BMW K1

Attention, the adapters for the BMW K1 only fit models with ABS

WE SET STANDARDS - Exclusively by MV

MV Motorrad-Technik GmbH succeeded in manufacturing an adjustable tube handlebar which fits virtually all motor bikes with tube handlebars – manufactured from 1910 until the present (and in the future!).

Tube handlebars have existed since the beginning of the mass produced motorcycles. So have different arm lengths. There are only a few lucky riders among us who take a bike and say: That’s perfect. Quite a lot of us would like to have the tube a little bit closer or perhaps a little bit higher. Most experienced riders have endured the well-known problems in the body and neck area after prolonged riding caused by the tensed position of the arms. Günter Verholen has been successful in solving this problem for motorcycles with tube handlebars.

The new development satisfies all demands on adjustability. A play of 70 mm for closer, higher or further of the handlebar is available.

This results in a natural ergonomic and a healthier sitting position.

Within only 2 minutes the steering tube is easily adapted to the course. Now you can enjoy riding with high tube position on a highway as well as a low tube position for sporty riding in the mountains.

The following applies only to consumer from Germany:
The adapter is shipped with TÜV approval. Your BMW K1 is listed.

The following applies to Germany consumers only:
The adapter is shipped with TÜV approval. The models which we list have been accepted. For all other models, an individual acceptance can be made. You will need to take your bike in for inspection and approval.

A ball for attaching your GPS can be fixed on the tube handlebars with 22 mm.
(see pictures)

TIP:
The brake hose is usually long enough. It just needs to be repositioned behind the handlebar to give you a few extra centimeters. Pay close attention that the lines are not stretched or pinched.

On the BMW K1, the baffle plate has to be adjusted a little and the brake line is extended with an adapter. This is included in the set.

F.Y.I.:
Please note that our list indicates only a small selection of motorcycles, however, our new handlebar adapter is suitable for all types of motorcycles with tube handlebars!!!

All MV accessories were assembled and tested at original motorcycles - without foreign modifications.