Cookie preferences
This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.
Configuration
Technically required
These cookies are necessary for the basic functions of the shop.
"Allow all cookies" cookie
"Decline all cookies" cookie
CSRF token
Cookie preferences
Currency change
Customer recognition
Customer-specific caching
Individual prices
PayPal payments
Selected shop
Session
Comfort functions
These cookies are used to make the shopping experience even more appealing, for example for the recognition of the visitor.
Note
Statistics & Tracking
Affiliate program
Track device being used
LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch For mounting two VA holders, black... more
LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch
For mounting two VA holders, black plastic coated, are used, which are simply attached to existing screws on the fairing. Longer new screws are provided, a rubber strip beats the panel against scratching.
The lamp cables can be obtained by either central mini-adhesive pads or cable grommet and hole (see photo).
The 3 Power LEDs provide a very good light output just with a current consumption of just 0.6 amps (7.5 watts) with 12.5 volts. The lamps are E-approved and do not need to be registered or demonstrated by TÜV (German Association for Technical Inspection).
The supplied wiring harness is pre-assembled to simplify installation.
The two LED fog lamps have about 120 degrees of illumination.
Switching is done with special electronics by double-clicking with the headlight flasher switch. Thus, the lamps can be switched at any time without having to take your hands off the handlebar.
A MotoBozzo switch control cable is connected to the on-board socket ignition plus, another to the high-beam plus cable. Thus, the system works completely independently, without affecting the CanBus system!
Function MotoBozzo switch:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off by 2 x short trigger light flashing/pass switch (click-click) or also switched on again.
After switching off the ignition, the lamps light up for about 60 seconds - Coming Home function.
If this is annoying, simply switch off by double-clicking.
The operating status is indicated by an LED.
If it is desired that the lamps are switched off after starting, simply pull off the purple wire and instead clamp the green wire.
These lights, switched on during the day, increase your safety, because as motorcyclist you are much better seen!
Scope of supply.
2 pcs. VA holders, plastic coated, incl. 2 LED-fog lights (each with 75 Watt)
1 pc. harness with relay, MotoBozzo switch and separate fuse (all pre-wired)
1 pc illustrated instructions
For mounting two VA holders, black plastic coated, are used, which are simply attached to existing screws on the fairing. Longer new screws are provided, a rubber strip beats the panel against scratching.
The lamp cables can be obtained by either central mini-adhesive pads or cable grommet and hole (see photo).
The 3 Power LEDs provide a very good light output just with a current consumption of just 0.6 amps (7.5 watts) with 12.5 volts. The lamps are E-approved and do not need to be registered or demonstrated by TÜV (German Association for Technical Inspection).
The supplied wiring harness is pre-assembled to simplify installation.
The two LED fog lamps have about 120 degrees of illumination.
Switching is done with special electronics by double-clicking with the headlight flasher switch. Thus, the lamps can be switched at any time without having to take your hands off the handlebar.
A MotoBozzo switch control cable is connected to the on-board socket ignition plus, another to the high-beam plus cable. Thus, the system works completely independently, without affecting the CanBus system!
Function MotoBozzo switch:
After switching on the ignition, the lamps switch on automatically.
Now the lamps can be switched off by 2 x short trigger light flashing/pass switch (click-click) or also switched on again.
After switching off the ignition, the lamps light up for about 60 seconds - Coming Home function.
If this is annoying, simply switch off by double-clicking.
The operating status is indicated by an LED.
If it is desired that the lamps are switched off after starting, simply pull off the purple wire and instead clamp the green wire.
These lights, switched on during the day, increase your safety, because as motorcyclist you are much better seen!
Scope of supply.
2 pcs. VA holders, plastic coated, incl. 2 LED-fog lights (each with 75 Watt)
1 pc. harness with relay, MotoBozzo switch and separate fuse (all pre-wired)
1 pc illustrated instructions
Read, write and discuss reviews... more
Customer evaluation for "LED Fog Light Set for BMW S1000XR incl. MotoBozzo Switch"
Write an evaluation
Evaluations will be activated after verification.
€54.34
*
Order number: 10355
€112.13
*
Order number: 10145-22.5
€157.38
*
Order number: 908654
€1,895.20
*
Order number: 907800
€157.38
*
Order number: 907921